Inspection 1. Remove the IMS control switch connector (A). 2. With the IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, ...
Component Location 1. Slide motor2. Front height motor3. Rear height motor4. Lumber support motor5. Power seat control switch6. Recline motor7. Recline control switch8. Lumber support switch ...
Inspection Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. Cover the front sensor to stop functioning. 3. Shine a light at the rear sensor. 4. The ECM should be darkened as soon as the rear sensor detects the light. ...
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage the hub bolts when removing the rear wheel & tire. 2. Loosen the bolt & nut and then remove the rear upper arm (A) from the rear axle. ...