Circuit Diagram |
Inspection With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A : Power seat control ...
Inspection Front Seat Heater Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to the BD group - "Console") 3. Remove the seat heater switch connectors ...
Removal 1. Remove the shift lever knob. (Refer to the BD group - "Console") 2. Remove the console upper cover (A). 3. Disconnect the connector from the console upper cover. 4. Remove the multimedia jack (B) from the console under cover after releasing the fixed hooks (A). Installation 1. Install the ...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. 4. Check that the resistance is within the specification. Temperature [°C(°F)]Resistance (k?)-40(-40)40.93 ~ 48.35-20(-4)13.89 ~ 16.030(32)5.38 ~ 6.0910(50)3.48 ~ ...