Inspection 1. Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal50Cluster ion generator fault * Diagnostic procedure refer to DTC code. ...
Component Location Components 1. Heater Case (LH)2. Separator3. Evaporator Core4. Shower Duct5. Heater Core Cover6. Heater Core7. Mode Actuator8. Mode Cam9. Temp Actuator10. Vent Door Arm11. Floor Door ...
Front wheel alignment When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels facing straight ahead. Prior to inspection, make sure that the front suspension and ...
Removal 1. Remove the negative (-) battery terminal. 2. Remove the driver seat in the car. (Refer to the BD group - "Front seat") 3. Remove the IMS module (A) after loosening 3 screws in the bottom of seat. 4. Disconnect the IMS module connector (A). Installation 1. Install the IMS module after reconnecting ...