Inspection |
1. |
Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch.
* Diagnostic procedure refer to DTC code. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad.
(Refer to BD group - “Crash Pad”) |
3. |
Loosen the screws and then remove the cluster ionizer (A). |
4. |
Installation is the reverse order of removal. |
Description 1. The function of cluster ion generator is cleaning air by sterilizing and dissolving of air conditioner. 2. The function of cluster ion generator is controlling mold caused by stench of air ...
...
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter. 2. Connect positive (+) battery cables to terminal ...
Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting ...