Kia Optima Hybrid: Heater / Mode Control Actuator Description and Operation

Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of vent> B/L > floor > mix.
Mode Control Actuator Components and Components Location

Component Location ...

Mode Control Actuator Repair procedures

Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: ETC (Electronic Throttle Control) System Description and Operation


Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Accelerator Position Sensor (APS) is used to receive driver input. The ECM uses the APS signal to calculate ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Repair procedures


Removal Back View Camera 1. Disconnect the negative(-) battery terminal. 2. Open the trunk and remove the trunk door trim. (Refer to the BD group - "Trunk") 3. Disconnect the back view camera connector(A). 4. Pull down and remove the back view camera holder(A). 5. Remove the back view camera (A) after ...

© 2025 Copyright www.koptimatfhev.com