Component Location |
Inspection 1. Ignition "OFF" 2. Disconnect the connector of temperature control actuator. 3. Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal ...
Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch ...
Components 1. Steering wheel2. Steering column3. ECU4. Motor5. Steering gear box MDPS Circuit Diagram Harness Connector TypePin NoDescriptionBattery1Battery -2Battery +Vehicle1IGN2-3-4-5-6-7High_CAN8Low_CAN ...
Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the crash pad side cover (A). 3. After loosening the mounting screws, then remove the crash pad lower panel (A). 4. Disconnect the crash pad lower switch connectors (A), diagnosis connector (B), crash pad ...