Kia Optima Hybrid: Hands Free System / Troubleshooting
| Troubleshooting |
| Problem | Possible cause | Solution |
| Not pairing | Bluetooth device of Car is not discoverable mode | Enter Bluetooth pairing (searching) mode |
| User’s phone is Bluetooth off mode | User’s phone set Bluetooth on | |
| Making an attempt pairing others bluetooth system | Check Bluetooth device name and address (12 word) to attempt paring Ex) 000B24FFF123 | |
| Pass key error | Input the passkey displayed on the audio screen into the phone. | |
| 5 phones have already been registered. | Delete paired phone list | |
| Bluetooth system cannot communicate with the phone. | Refer to IOP sheet ?IOP : Inter-operability | |
| Not connection | User’s phone or Bluetooth device of Car dose not register Bluetooth device to connect | Retry pairing |
| Bluetooth system cannot communicate with the phone. | Waiting 1minute then Retry connection or phone power off/on. Refer to IOP sheet | |
| Not redial | User phone system issue | Push the 2 times Send button |
| Not accept call | User phone system issue | Refer to IOP sheet |
| Not dialing | User’s phone playing other menu (internet, mp3, game, etc..) | Stop other menu then set normal mode |
| Bluetooth system cannot communicate with the phone | Refer to IOP sheet |
Hands Free Mic Repair procedures
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") 3. Remove the handsfree mic (A) after disconnect the connector from loof top. ...
Panoramaroof
...
Other information:
Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Driver Airbag (DAB) Module and Clock Spring Description and Operation
Description Driver Airbag (DAB) is installed in the steering wheel and electrically connected to SRSCM via the clock spring. It protects the driver by deploying the airbag when frontal crash occurs. The SRSCM determines deployment of the Driver Airbag (DAB). Never attempt to measure the ...
Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Head Lamps Repair procedures
Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) (2) Check the fuse and relay. (3) Check the polarity of ballast. (If the polarity are changed, low beam doesn''t lighten) (4) Check the bulb connector securely. ...