Inspection |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the roof trim.
(Refer to the BD group - "Roof trim") |
3. |
Remove the handsfree mic (A) after disconnect the connector from loof top.
|
4. |
Check the continuity of Mic between terminals. |
Inspection 1. Check the hands free remote control switch for resistance between terminals in each switch position. [Audio/ Bluetooth] [Voice recognition] [Bluetooth] SwitchConnectorterminalResistance(±5%)Send2-718.91k?End ...
Troubleshooting ProblemPossible causeSolutionNot pairingBluetooth device of Car is not discoverable modeEnter Bluetooth pairing (searching) modeUser’s phone is Bluetooth off modeUser’s phone set Bluetooth ...
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the lighting switch of the multi-function switch. (Refer to the multi-function switch) 3. With the front fog lamp switch, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function ...
Personal Protective Equipment NameIllustrationDescriptionInsulation gloveUsed when inspecting or working on the high voltage components[Insulation performance : 1000V / 300A or above]Insulation shoesUsed when inspecting or working on the high voltage componentsInsulation clothesInsulation helmetSafety ...