Inspection 1. Remove the driver door trim. (Refer to the BD group - "Front door") 2. Remove the switch assembly connector (A) from the door trim. 3. Check for continuity between the terminal No.1 and No.2. ...
Component Location 1. Rear defogger relay2. EWP relay3. Deicer relay4. ACC realy5. IG1 relay6. IG2 relay7. Wiper relay8. Rain sensor relay9. Burglar alarm horn relay10. Blower relay11. Fuel pump relay12. ...
Component Location 1. Back view camera2. AVN monitor ...
Removal and Installation Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat. 1. Drain engine coolant so its level is below thermostat. 2. Disconnect the radiator lower hose ...