Components |
Inspection Power Relay Test (Type A) – Do not use pliers. – Pliers will damage the relays, which could cause the engine to stall or not start. – Carefully remove the relay using the ...
Fuse Inspection 1. Be sure there is no play in the fuse holders, and that the fuses are held securely. 2. Are the fuse capacities for each circuit correct? 3. Are there any blown fuses? If a fuse is to ...
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 3. Disconnect the injector connector (A). 4. Remove the wiring harness bracket mounting bolt (B). ...
Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (C) after disconnecting the heater connector (A) and BSD warning connector (B). 3. Remove the door mirror housing (A) after loosening the mounting screw. Take care not to damage the ...