| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Remove the air duct (A).
|
| 3. |
Remove the air cleaner assembly.
|
| 4. |
Remove the solenoid valve connector (A).
|
| 5. |
Measure resistance between signal terminal and ground terminal. |
| 6. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
Line Pressure Control Solenoid Vale Schematic DiagramsCircuit Diagram ...
35R Clutch Control Solenoid Valve (35R/C_VFS) Description and OperationDescription 35R clutch control solenoid valve(35R/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure to the 35R clutch. ...
Refrigerant System Service Basics • Since the electric compressor uses high-voltage, you should use PVE or POE oil which have high Volumetric Resistivity. • Do not use the same A/C recovery / charging station as conventional belt-driven compressors. If the PVE or POE oil of the system ...
Interior A Front pillar trim mounting hole (O12)Front pillar trim mounting hole (O8.4)Cowl crossbar mounting hole (O9)Cowl side trim mounting hole(8.4X8.4)Front door checker mounting hole (O13)Seat belt height adjust upper mounting hole (O12)Seat belt height adjust upper mounting hole (O12)Front seat ...