Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the overhead console lamp assembly.
(Refer to the BD group - "Roof trim") |
3. |
Check for continuity between the terminals. |
4. |
If the continuity is not as specified, replace the panoramaroof switch (A). |
Circuit Diagram (1) Circuit Diagram (2) ...
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") 3. Disconnect the panoramaroof motor (A) connector. 4. Ground the terminals as ...
Components 1. Telematics unit (TMU)2. Roof Antenna (GPS)3. Multimedia jack4. AVN head unit5. Mic (Built in OHC) ...
Removal 1. Remove the cylinder head cover. 2. Set No.1 cylinder to TDC/compression. a. Turn the crankshaft pulley and align its groove with the timing mark "T" of the lower timing chain cover. b. Check that the mark(A) of the CVVT sprockets are in straight line on the cylinder head surface as shown in ...