Circuit Diagram |
Inspection Room Lamp 1. Check that the switch operates properly after disconnecting the room lamp connector (A). [A type] [B type] Removal Room Lamp 1. Disconnect the negative(-) battery terminal. 2. Carefully ...
Inspection Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.Removal 1. Disconnect the negative (-) ...
Component Location 1. Audio unit2. Midrange speaker3. Glass antenna (AM/FM)4. Front door speaker5. Rear door speaker6. Antenna feeder cable7. Feeder cable joint connector8. Multimedia jack9. Roof antenna (SDARS)10. Hands free mic (Built in OHC)11. Extention & Feeder cable joint connector ...
Component Location(1) 1. Head lamp (Low)2. Head lamp (High)3. Turn signal lamp (and Posistion lamp)4. Position lamp (LED) and DRL5. Side marker6. Front fog lamp7. Overhead console lamp8. Room lamp9. Vanity lamp10. Turn signal lamp (O/S mirror) Component Location(2) 1. Tail lamp2. Back up lamp3. Stop/Tail ...