Inspection |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Loosen 2 screws holding the overhead console (A). |
3. |
Disconnect the connectors of sunroof switch (A) and lamp switch (B) then remove the overhead console lamp assembly. |
4. |
If necessary to replace the bulb, replace the bulb (C) after disconnecting the connectors. |
Installation |
1. |
Install the overhead console lamp after connecting the sunroof switch connector and lamp connector. |
2. |
Install the lens after tightening 2 screws. |
Circuit Diagram ...
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the license lamp (A) after pushing the pins fixed on the both side of license lamp. 3. Remove the bulb (B) by turning it counterclockwise. ...
Specification Smart Key Unit ItemsSpecificationRated voltageDC 12VOperating voltageDC 9 ~ 16VOperating temperature-30°C ~ 75°C (-22°F ~ 167°F)LoadMax. 2.9mA (When welcome light off)(When welcome light function ON, increase 2mA - 60days average) RF Receiver ItemsSpecificationFrequency315 MHzAntenna ...
Removal 1. Loosen the windshield wiper arm nut (B) after removing a wiper cap (A). 2. Remove the windshield wiper arm and blade (A). 3. If necessary, release the wiper blade fixing clip by pulling up and remove the wiper blade from the inside radius of wiper arm. 4. Disconnect the washer hose (A) connected ...