Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the license lamp (A) after pushing the pins fixed on the both side of license lamp. |
3. |
Remove the bulb (B) by turning it counterclockwise. |
Installation |
1. |
Install the bulb. |
2. |
Install the license lamp assembly. |
Inspection Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.Removal 1. Disconnect the negative (-) ...
Inspection 1. It will be able to diagnose defects of hazard switch with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and self diagnosis. 2. Select model and "BCM". 3. ...
Removal and Installation 1. Remove the front muffler (A). Tightening torque: 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft) 2. Remove the catalytic converter (A). Tightening torque: 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft) 3. Remove the center muffler (A). Tightening torque: 39.2 ~ ...
Inspection TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side check point. If the problem is found, repair it. Specification: Below 1? 2. Test TCM Connector: Disconnect the TCM connector ...