Kia Optima Hybrid: Engine Control System / Intake Air Temperature Sensor (IATS) Repair procedures

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Engine Control/Fuel System / Engine Control System / Intake Air Temperature Sensor (IATS) Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the IATS connector.

3.	Measure resistance between the IATS terminals 3 and 4.

Check that the resistance is within the specification.

Temperature [°C(°F)]	Resistance (k?)
-40(-40)	40.93 ~ 48.35
-20(-4)	13.89 ~ 16.03
0(32)	5.38 ~ 6.09
10(50)	3.48 ~ 3.90
20(68)	2.31 ~ 2.57
40(104)	1.08 ~ 1.21
50(122)	1.56 ~ 1.74
60(140)	0.54 ~ 0.62
80(176)	0.29 ~ 0.34

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) terminal.

2.	Disconnect the manifold absolute pressure sensor connector (A).

3.	Remove the mounting bolt (B), and then remove the sensor from the surge tank.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Insert the sensor in the installation hole and be careful not to damage when installation.

Install in the reverse order of removal.

Manifold absolute pressure sensor mounting bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Intake Air Temperature Sensor (IATS) Schematic Diagrams

Circuit Diagram ...

Engine Coolant Temperature Sensor (ECTS) Description and Operation

Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor whose resistance ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Passenger Airbag (PAB) Module Description and Operation

Description The passenger airbag (PAB) is installed inside the crash pad and protects the front passenger in the event of a frontal crash. The SRSCM determines if and when to deploy the PAB. Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Repair procedures

Inspection Front Door Lock Actuator Inspection 1. Remove the front door trim. (Refer to the BD group - "Front door") 2. Remove the front door module. 3. Disconnect the 7P connector from the actuator. 4. Check actuator operation by connecting power and ground according to the table. To prevent damage ...