Inspection |
1. |
Ignition "OFF" |
2. |
Disconnect evaporator temperature sensor. |
3. |
Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Specification
|
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Loosen the mounting screw and then remove the crash pad lower cover (A). |
3. |
Remove the evaporator temperature sensor (A), by pulling it after rotating 90° in a counterclockwise direction. |
4. |
Installation is the reverse order of removal. |
Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator freezing by excessive cooling ...
Component Location ...
Components 1. Driveshaft nut2. Brake disc3. Hub4. Wheel bearing5. Snap ring6. Dust cover7. Knuckle8. Driveshaft ...
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air duct (A). 3. Remove air cleaner assembly (B). 4. Disconnect the brake fluid level switch connector (A), and remove the reservoir cap. Be sure to completely remove foreign substances from ...