Kia Optima Hybrid: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Engine Control/Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection

Check the signal waveform of the CMPS and CKPS using the GDS.

Specification: Refer to “Wave Form”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) terminal.

2.	Disconnect the crankshaft position sensor connector (A).

3.	Remove the protector (A).

4.	Remove the mounting bolt (A), and then remove the crankshaft position sensor.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage when installation.

Install in the reverse order of removal.

Crankshaft position sensor mounting bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Crankshaft position sensor protector mounting bolt (M6):

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Crankshaft Position Sensor (CKPS) Schematic Diagrams

Circuit Diagram ...

Camshaft Position Sensor (CMPS) Description and Operation

Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the piston position ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Shift Cable Components and Components Location

Components 1. Shift lever assembly3. Shift cable assembly 2. Shift cable retainer? ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Air Ventilation Seat Repair procedures

Removal [Front Seat] 1. Remove the front seat assembly. (Refer to Body group - "Front Seat") 2. Remove the seat back cover and cushion cover. (Refer to Body group - "Front Seat") 3. Remove the ventilation duct (A) after loosening screws and removing fixing hook (B). 4. Remove the air ventilation panel ...