Circuit Diagram |
Wave Form ...
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. ...
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure ...
Removal The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag. 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the front seat assembly. (Refer to the ...