Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the smart junction box cover. 3. Remove the crash pad side switch assembly (A) as shown below picture. Put on gloves to ...
Component Location 1. Start Stop Button(SSB)2. FOB key3. Trunk lid open switch4. Smart key unit5. RF receiver6. Body control module7. Interior antenna 18. Interior antenna 29. ...
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage the hub bolts when removing the rear wheel & tire. 2. Loosen the nut and then remove the rear stabilizer link (B) from the rear lower arm (A). ...
Inspection 1. Remove the IMS control switch connector (A). 2. With the IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the IMS control switch. Driver Power Seat Control Switch (For IMS) Removal 1. Disconnect ...