Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad") |
3. |
Remove the crash pad side switch assembly (A) as shown below picture.
|
4. |
Remove the crash pad lower switch assembly (B) after disconnecting the connector (A). |
Installation |
1. |
Install the blind spot detection switch after connecting the connector. |
2. |
Install the crash pad lower panel. |
Inspection |
1. |
Disconnect the BSD switch connector from the crash pad lower switch assembly. |
2. |
Operate the BSD switch, then check for continuity between terminals BSD switch connector. |
Removal 1. Disconnect the 12V battery negative (-) cable. 2. Remove the under cover (A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 3. Remove the electric oil pump (EOP) connector (A, B). 4. Remove the EOP (A) after removing the bolt and nut. Tightening torque : 42.2 ~ 53.9 ...
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct (A). Tightening torque: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft) 3. Remove the air cleaner assembly. (1) Disconnect the breather hose (A). (2) Disconnect the air intake hose (B) and then remove the air cleaner assembly (C). Tightening ...