Kia Optima Hybrid: Blind Spot Detection System / Blind Spot Detection Switch Components and Components Location

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Switch Components and Components Location

Component

Blind Spot Detection Radar Calibration Description and Operation

Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed ...

Blind Spot Detection Switch Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the crash pad side switch assembly (A) as shown below picture. ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Electric A/C compressor Troubleshooting


Troubleshooting Fault codeFail descriptionRemedy60Compressor CAN signal fault1. Check HV, LV  connector connection. 2. Check LV connector pin condition. 3. Check vehicle inverter fuse condition. 4. A/C ON then check compressor operation. 5. If not operate, replace compressor.61Compressor ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Components and Components Location


Components Location 1. Sub frame2. Assist arm3. Trailing arm4. Rear disc5. Rear upper arm6. Rear shock absorber7. Coil spring ...

© 2025 Copyright www.koptimatfhev.com