Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad") |
3. |
Remove the crash pad side switch assembly (A) as shown below picture.
|
4. |
Disconnect the rheostat connector (A) from lower crash pad switch. |
5. |
Operate the rheostat switch and check for continuity between terminals. |
Inspection 1. It will be able to diagnose defects of hazard switch with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and self diagnosis. 2. Select model and "BCM". 3. ...
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the lighting switch of the multi-function switch. (Refer to the multi-function switch) 3. With the front fog lamp switch, make sure ...
Inspection Power Seat Motor 1. Disconnect the connectors for each motor. A : Front height motor B : Slide motor C : Rear height motor D : Recline motor E : Lumber support motor 2. With the battery connected directly to the motor terminals, check if the motors run smoothly. 3. Reverse the connections ...
Description Front seat belt anchor pretensioner operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat and it is an equipment to make up for the existing short stroke. Front seat belt anchor pretensioner ...