Specification |
Items | Specification |
Rated voltage | DC 12V |
Operating voltage | DC 9 ~ 16V |
Operating temperature | -30°C ~ 75°C (-22°F ~ 167°F) |
Load | Max. 2.9mA (When welcome light off) (When welcome light function ON, increase 2mA - 60days average) |
Items | Specification |
Frequency | 315 MHz |
Antenna type | FSK (Frequency Shift Keying) |
Items | Specification | ||||
Battery | Lithium battery 3V 1EA (CR2032) | ||||
Distance | 30m from vehicle, RF : 30m, Passive(LF) : 0.7m | ||||
Battery life | More than 2years (10 times / a day)
| ||||
Push buttons | 4 (Door lock / unlock, Trunk hold / Panic) | ||||
Frequency(Rx) | 125 kHz | ||||
Frequency(Tx) | 315 MHz | ||||
Numbers | 2EA |
Items | Specification |
Rated voltage | DC 12V |
Operating voltage | DC 9 ~ 16V |
Operating temperature | -30°C ~ 75°C (-22°F ~ 167°F) |
Frequency | 125kHz |
Numbers | Interior(3EA), Door(2EA), Bumper(1EA) |
...
Component Location (1) 1. Buzzer2. RF receiver3. Smart key unit4. Interior antenna 15. Interior antenna 26. Trunk antenna7. Bumper antenna Component Location (2) 1. Door outside handle2. Trunk lid open ...
Component location 1. Driveshaft (LH) 2. Driveshaft (RH) Components 1. BJ assembly2. Circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Snap ring12. TJ case13. Circlip ...
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. To remove the seat belt anchor pretensioner (C), keep on pushing the lock pin (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B). 3. Remove the door scuff ...