Replacement |
|
1. |
Remove the front bumper.
(Refer to the BD group - "Front Bumper") |
2. |
Loosen the mud guard mounting screws. |
3. |
After loosening the mounting screws and clips, then remove the side sill moulding (A). |
4. |
After loosening the mounting screw and bolt, then remove the front bumper side mounting bracket (A). |
5. |
After loosening the fender mounting bolts, then remove the fender (A). |
6. |
Installation is the reverse of removal. |
...
Replacement Hood Assembly Replacement • When removing and installing the hood, an assistant is necessary. • Be careful not to damage the hood and body. • When removing the clips, use ...
Inspection With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A : Power seat control switch B : Lumber support switchRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove ...
Inspection ATF level Check When checking the ATF level, be careful not to enter dust, foreign matters, etc. from fill hole. 1. Remove the air duct (A). 2. Remove the eyebolt (A). 3. Add ATF SP-IV 700cc to the ATF injection hole (A). 4. Start the engine. (Don’t step on brake and accelerator ...