Kia Optima Hybrid: Emission Control System / Specifications

Specifications
Purge Control Solenoid Valve (PCSV)
? Specification
Item
Specification
Coil Resistance (?)
19.0 ~ 22.0 [20°C(68°F)]

Fuel Tank Pressure Sensor (FTPS)
? Type: Piezo-Resistive Pressure Sensor
? Specification
Pressure [kPa (kgf/cm?, in H2O)]
Output Voltage (V)
-6.67 (-0.068, -26.8)
0.5
0
2.5
+6.67 (0.068, 26.8)
4.5

Canister Close Valve (CCV)
? Specification
Item
Specification
Coil Resistance (?)
19.8 ~ 21.8 [20°C(68°F)]

NVLD(Natural Vacuum Leakage Detection)
? Specification
Item
Current (mA)
Switch open
Switch close
Power supply
Approx. 2.0
Approx. 3.0
Data line
Approx. 10.0
-

Tightening Torques
Item
kgf.m
N.m
lb-ft
Positive crankcase ventilation valve installation
0.19 ~ 0.29
1.9 ~ 2.8
1.4 ~ 2.1
Canister protector installation bolt
0.9 ~ 1.4
8.8 ~ 13.7
6.5 ~ 10.1
Canister installation bolt
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3
Auxiliary canister installation nut
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3
Fuel tank air filter bracket installation bolt
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3
Natural Vacuum Leakage Detection (NVLD) installation screw
0.2 ~ 0.3
2.3 ~ 3.3
1.7 ~ 2.5

High Voltage Shut-off Procedures

High Voltage Shut-off Procedures     Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow ...

Components and Components Location

Components Location 1. PCV valve2. Canister3. Purge control solenoid valve (PCSV)4. Fuel tank pressure sensor (FTPS)5. NVLD (Natural Vaccum Leakage Detection) Module6. Fuel level sender (FLS)7. Canister ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Power Door Lock Switch Repair procedures


Inspection Driver Door Lock Switch Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front door") 3. Disconnect the connector from the power window switch module. 4. Check for continuity between the terminals in each switch position ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Intake Actuator Description and Operation


Description 1. The intake actuator is located at the blower unit. 2. It regulates the intake door by signal from control unit. 3. Pressing the intake selection switch will shift between recirculation and fresh air modes. ...

© 2025 Copyright www.koptimatfhev.com