Schematic Diagram |
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of ...
Components (1) Control Panel (Dual A/C & Heater Controller - A) Connector pin function (1) ConnectorPIN NO.FunctionConnectorPIN NO.FunctionConnector (A)1ILL+(TAIL)Connector (A)29ECV (+)2SENSOR REF (+5V)30ECV (-) (GND)3HAZARD SIGNAL31PHOTO SENSOR (-) -LEFT4ACC32PHOTO SENSOR (-) -RIGHT5MODE ACT''R ...
Compression Pressure Inspection If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. Engine may start anytime the vehicle is in READY mode.1. Warm up and stop engine. 1. Warm up and stop engine. Allow the engine to ...