Tire wear |
1. |
Measure the tread depth of the tires.
|
2. |
If the remaining tread depth (A) is less than the limit, replace the tire.
|
...
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) When using an impact gun, final tightening torque should ...
Removal and Installation 1. Disconnect the battery negative terminal (B) first, then the positive terminal (A). Tightening torque : (+) terminal (A) : 7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft) (-) terminal (B) : 4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft) 2. Disconnect the vent hose (C). 3. Remove ...
Calibration Procedure If the compass has been calibrated or set to variance zone number incorrectly, or you are driving in specific places (tunnel, parking lot in building, underground parking lot, near transformer substation, etc.), the below conditions may occur. • The display read "C". • The compass ...