Inspection |
1. |
After disconnecting the vapor hose from the PCV valve, remove the PCV valve. |
2. |
Reconnect the PCV valve to the vapor hose. |
3. |
Run the engine at idle, then put a finger over the open end
of the PCV valve and make sure that intake manifold vacuum can be felt.
|
4. |
If the vacuum is not felt inspect PCV operation, if operating correctly clean or replace the vapor hose. |
Schematic Diagram ...
Operation Principle ...
Circuit Diagram ...
Components 1. Floor console assembly2. Gear boots3. Floor console upper cover4. Floor console extension cover [LH]5. Floor console extension cover [RH]6. Console rear bracket ...