Kia Optima Hybrid: Lighting System / Front Fog Lamps Repair procedures
| Inspection |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the lighting switch of the multi-function switch. (Refer to the multi-function switch) |
| 3. |
With the front fog lamp switch, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.
Front Fog Lamp
|
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front wheel guard clip(2EA).
(Refer to the BD group - "Front bumper") |
| 3. |
Disconnect the front fog lamp connector (A).
|
| 4. |
Replace the front fog bulb (A) turning it in the counter clock-wise direction.
|
| Installation |
| 1. |
Install the front fog bulb. |
| 2. |
Reconnect the lamp connector. |
| 3. |
Install the front bumper. |
Rheostat Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the crash pad side switch assembly (A) as shown below picture. ...
High Mounted stop lamp Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the rear seat. (Refer to the BD group - "Rear seat") 3. Remove the package tray trim (A). (Refer to the BD group -"Interior trim") 4. Remove ...
Other information:
Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Electric A/C compressor Troubleshooting
Troubleshooting Fault codeFail descriptionRemedy60Compressor CAN signal fault1. Check HV, LV connector connection. 2. Check LV connector pin condition. 3. Check vehicle inverter fuse condition. 4. A/C ON then check compressor operation. 5. If not operate, replace compressor.61Compressor ...
Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Front Stabilizer Bar Repair procedures
Replacement 1. Remove the front wheel & tire. Tightening torque: 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1~79.6lb-ft) Be careful not to damage to the hub bolts when removing the front wheel & tire. 2. Loosen the bolt (A) and then disconnect the universal joint assembly from the pinion ...