Kia Optima Hybrid: Driveshaft and axle / Rear Axle Assembly

Front Driveshaft Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove wheel nuts, front wheel and tire from front hub. Tightening torque: 88.2 ~ 107.8 N.m ...

Rear Hub - Carrier Components and Components Location

Components 1. Rear carrier assembly2. Parking brake assembly3. Rear hub assembly4. Rear brake disc ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Seat Track Position Sensor (STPS) Repair procedures


Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. (Refer to BD group) 3. Loosen the two STPS screws, then remove the STPS after disconnecting the STPS connector. Installation     Be sure to install ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Anchor Pretensioner (APT) Description and Operation


Description Front seat belt anchor pretensioner operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat and it is an equipment to make up for the existing short stroke. Front seat belt anchor pretensioner ...

© 2023 Copyright www.koptimatfhev.com