Kia Optima Hybrid: Engine Control System / Purge Control Solenoid Valve (PCSV) Repair procedures

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Engine Control/Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the PCSV connector.

3.	Measure resistance between the PCSV terminals 1 and 2.

Check that the resistance is within the specification.

Specification: 19.0 ~ 22.0? [20°C(68°F)]

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) terminal.

2.	Disconnect the purge control solenoid valve connector (A).

3.	Disconnect the vapor hoses (B) from the purge control solenoid valve.

4.	Remove the valve from the bracket in the direction of the arrow.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Use care to keep foreign material out of the valve.

•	Install the purge control solenoid valve after lifting the support pin (A) of the bracket.

Install in the reverse order of removal.

Purge control solenoid valve bracket mounting bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Purge Control Solenoid Valve (PCSV) Schematic Diagrams

Circuit Diagram ...

CVVT Oil Control Valve (OCV) Description and Operation

Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Troubleshooting

Trouble Shooting Ignition System SymptomSuspect areaRemedyVehicle indicates Ready in dash, but engine will not run when requested by the HPCU (HEV module).Ignition coilInspect ignition coil, or replace as requiredSpark plugsInspect spark plugs, or replace as requiredIgnition wiring disconnected or brokenRepair ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Underdrive Brake Control Solenoid Valve (UD/B_VFS) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Remove the air duct (A). Tightening torque: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft) 3. Remove the air cleaner assembly. (1) Disconnect the breather hose (A). (2) Disconnect the air intake hose (B) and then remove the air cleaner assembly (C). Tightening ...