Schematic Diagrams |
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front door") 3. Disconnect the connector and remove the door mirror switch (A) ...
Inspection Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor input signal. 2. If the wiper switch has been left in automatic mode with the vehicle ignition OFF, and then the vehicle ...
Removal Pressure Side Impact Sensor • Removal of the airbag must be performed according to the precautions/procedures described previously. • Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s). • Do not turn the ignition switch ON and ...