Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door") |
3. |
Disconnect the connector and remove the door mirror switch (A) after removing the screws. |
4. |
Check for continuity between the terminals in each switch position according to the table.
[Power Mirror Switch] [Power folding Mirror Switch] |
Schematic Diagrams ...
Inspection 1. Remove the front door quadrant delta cover. (Refer to the BD group - "Front door") 2. Disconnect the power door mirror connector from the harness. 3. Apply battery voltage to each terminal ...
Inspection Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on the tin foil, moving the tin foil along the grid line to check for open circuits. 1. Turn on the defogger switch and use a voltmeter to measure the voltage of ...
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage the hub bolts when removing the rear wheel & tire. 2. Loosen the nut and then remove the rear stabilizer link (B) from the rear lower arm (A). ...