Inspection |
1. |
Remove the front door quadrant delta cover.
(Refer to the BD group - "Front door") |
2. |
Disconnect the power door mirror connector from the harness. |
3. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly. Mirror Heater Inspection Turn Signal Lamp BSD Warning Lamp Mirror folding Inspection |
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front door") 3. Disconnect the connector and remove the door mirror switch (A) ...
...
Components 1. Intake manifold assembly 2. Intake manifold gasket3. ETC (Electronic throttle body)4. Intake manifold stay ...
Replacement Removal • Put on gloves to protect your hands. • Use seat covers to avoid damaging any surfaces. 1. Remove the following items. • Front pillar trim (Refer to the BD group - "Interior Trim") • ECM mirror (Refer to the BD group - "Mirror") • Rain sensor (Refer to the ...