| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Remove the air duct (A).
|
| 3. |
Remove the air cleaner assembly.
|
| 4. |
Remove the solenoid valve connector (A).
|
| 5. |
Measure resistance between signal terminal and ground terminal. |
| 6. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
Overdrive Clutch Control Solenoid Valve (OD/C_VFS) Schematic DiagramsCircuit Diagram ...
SS-A Solenoid Valve (ON/OFF) Description and OperationDescription The SS-A solenoid valve is attached to the valve body and is an SS-A solenoid valve that is used to change gears. ...
Specification Smart Key Unit ItemsSpecificationRated voltageDC 12VOperating voltageDC 9 ~ 16VOperating temperature-30°C ~ 75°C (-22°F ~ 167°F)LoadMax. 2.9mA (When welcome light off)(When welcome light function ON, increase 2mA - 60days average) RF Receiver ItemsSpecificationFrequency315 MHzAntenna ...
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) Control type : Normal low type Control pressure kpa(kgf/cm?, psi)490.33 (5.0, 71.12) Internal resistance(?)10 ~ 11 ...