Kia Optima Hybrid: Automatic Transaxle Control System / SS-A Solenoid Valve (ON/OFF) Description and Operation

Description
The SS-A solenoid valve is attached to the valve body and is an SS-A solenoid valve that is used to change gears.

Overdrive Clutch Control Solenoid Valve (OD/C_VFS) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Remove the air duct (A). Tightening torque: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft) 3. Remove the air cleaner assembly. (1) Disconnect the breather hose ...

SS-A Solenoid Valve (ON/OFF) Specifications

Specifications ON/OFF Solenoid Valve(SS-A, SS-B) Control type : Normal low type Control pressure kpa(kgf/cm?, psi)490.33 (5.0, 71.12) Internal resistance(?)10 ~ 11 ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Output Speed Sensor Repair procedures


Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal     • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Rear Shock Absorber Repair procedures


Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage the hub bolts when removing the rear wheel & tire. 2. Loosen the bolt & nut and then disconnect the shock absorber (A) from the rear axle. ...

© 2022 Copyright www.koptimatfhev.com