Specifications |
Operation condition (°C)°F | ((-)40 ~ 150)) -104 ~ 302 | |
Air gap(mm)in. | (0.25 ~ 1.9) | |
0.00984 ~ 0.0748 | ||
Output voltage | High | 1.18 ~ 1.68 |
Low | 0.59 ~ 0.84 |
Description Input speed sensor is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the TCM. The sensor provides critical input data that''s ...
Circuit Diagram ...
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the glove box housing. (Refer to the BD group - "Crash pad") 3. Remove the VESS unit (A) with bracket after loosening the mounting nuts (2EA) and disconnecting the connector. Installation 1. Install the VESS unit and connect the connector. ...
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") 3. Disconnect the panoramaroof motor (A) connector. 4. Ground the terminals as below table, and check that the panoramaroof unit operates. – When inspecting the panoramaroof ...