Specification |
Accelerator Position | Output Voltage (V) | |
APS1 | APS2 | |
C.T | 0.7 ~ 0.8 | 0.29 ~ 0.46 |
W.O.T | 3.85 ~ 4.35 | 1.93 ~ 2.18 |
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...
Circuit Diagram ...
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (C) from the mirror holder after disconnecting the heater connector (A) and BSD warning connector (B). 3. Remove the BSD warning lamp (A). Installation 1. Install the BSD warning lamp and mirror. 2. Connect the negative (-) ...
Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. BLOWER speedManual VoltageAuto Voltage13.4Auto Low(4.5V)24.64.5~5.535.95.6~6.747.26.8~7.758.37.8~8.969.59.0~10.1711.310.2~11.38B+? ...