Kia Optima Hybrid: Fuel Delivery System / Accelerator Pedal Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Disconnect the accelerator position sensor connector (A).

3.
Remove the mounting nuts (B) and bolt (C), and then remove the accelerator pedal module.

Installation
1.
Install in the reverse order of removal.

Accelerator pedal module mounting bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Accelerator pedal module mounting nut:
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.9 lb-ft)

Filler-Neck Assembly Repair procedures

Removal 1. Lift the vehicle. 2. Disconnect the fuel filler hose (A). 3. Disconnect the ventilation hose (B) from the fuel tank air filter. 4. Open the fuel filler door and then remove the filler-neck installation ...

Delivery Pipe Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: ETC (Electronic Throttle Control) System Repair procedures


Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle AngleOutput Voltage (V)TPS 1TPS 2C.T0.3 ~ 0.94.2 ~ 5.0W.O.T1.5 ~ 3.03.3 ~ 3.8 3. Turn the ignition switch OFF and ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Air Ventilation Seat Description and Operation


Description Using the blows power of FAN on seat, remove the moisture, sweat and warmth from occupants and surface of seats. It inhales the indoor air through the blower installed at the seat cushion lower part, and supplies the air into the seat cushion and the seat back through the duct. It sends a ...

© 2025 Copyright www.koptimatfhev.com