Description |
1. |
The intake actuator is located at the blower unit. |
2. |
It regulates the intake door by signal from control unit. |
3. |
Pressing the intake selection switch will shift between recirculation and fresh air modes. |
Component Location ...
Inspection 1. Ignition "OFF". 2. Disconnect the intake actuator connector. 3. Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grounding terminal ...
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Disconnect the crankshaft position sensor connector (A). 3. Remove the protector (A). 4. Remove ...
Inspection 1. Remove the driver door trim. (Refer to the BD group - "Front door") 2. Remove the switch assembly connector (A) from the door trim. 3. Check for continuity between the terminal No.1 and No.2. NODescriptionNODescription1Fuel filler door B+3GND2Fuel filler door actuator4Trunk lid switch 4. ...