Signal Waveform |
Circuit Diagram ...
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal • Be sure to read and follow the “General ...
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage the hub bolts when removing the rear wheel & tire. 2. Loosen the bolt & nut and then remove the rear upper arm (A) from the rear axle. ...
Inspection 1. Remove the driver door trim. (Refer to the BD group - "Front door") 2. Remove the switch assembly connector (A) from the door trim. 3. Check for continuity between the terminal No.1 and No.2. NODescriptionNODescription1Fuel filler door B+3GND2Fuel filler door actuator4Trunk lid switch 4. ...