Special Service Tools |
Tool(Number and Name) | Illustration | Use |
Deployment tool 0957A-34100A | Airbag deployment tool. | |
Deployment adapter 0957A-3Q100 | Use with deployment tool. (DAB, CAB, BPT, APT) | |
Deployment adapter 0957A-2E110 | Use with deployment tool. (PAB) | |
Deployment adapter 0957A-3F100 | Use with deployment tool. (SAB) | |
Dummy 0957A-38200 | Simulator to check the resistance of each wiring harness. | |
Dummy adapter 0957A-2E100 | Use with dummy (PAB) | |
Dummy adapter 0957A-3F000 | Use with dummy (SAB) | |
Dummy adapter 0957A-2G000 | Use with dummy (DAB, CAB, BPT, APT) |
Personal Protective Equipment |
Name | Illustration | Description |
Insulation glove | Used when inspecting or working on the high voltage components [Insulation performance : 1000V / 300A or above] | |
Insulation shoes | Used when inspecting or working on the high voltage components | |
Insulation clothes | ||
Insulation helmet | ||
Safety glasses | Used in the case below • During Removal & installation or inspection of the high voltage battery terminals or wiring, which spark might happen. • During working on the high voltage battery pack assembly. | |
Face shield | ||
Insulation mat | Putting the removed high voltage components on the insulation mat to prevent safety accidents. | |
Insulation sheet | Covering
the high voltage components with insulation sheet to prevent people who
don’t wear the personal protective equipment from safety accidents. |
Specification ItemResistance (?)Driver Airbag (DAB)1.88 ~ 5.8Passenger Airbag (PAB)1.88 ~ 5.8Side Airbag (SAB)1.88 ~ 5.8Curtain Airbag (CAB)1.88 ~ 5.8Seat Belt Pretensioner (BPT)1.88 ~ 5.8Anchor Pretensioner ...
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally ...
Description 1. The ESC OFF switch is for the user to turn off the ESC system. 2. The ESC OFF lamp is on when ESC OFF switch is engaged. ...
Removal 1. Remove the negative (-) battery terminal. 2. Remove the driver seat in the car. (Refer to the BD group - "Front seat") 3. Remove the IMS module (A) after loosening 3 screws in the bottom of seat. 4. Disconnect the IMS module connector (A). Installation 1. Install the IMS module after reconnecting ...