Specifications |
Power supply (V) | 12 |
Output type | Combination of output signals |
PIN No. | P | P-R | R | R-N | N | N-D | D |
Signal "1" | 12V | 12V | 0 | 0 | 0 | 0 | 0 |
Signal "2" | 0 | 12V | 12V | 12V | 0 | 0 | 0 |
Signal "3" | 0 | 0 | 0 | 12V | 12V | 12V | 0 |
Signal "4" | 0 | 0 | 0 | 0 | 0 | 12V | 12V |
Description Inhibitor switch monitors the lever''s position (P,R,N,D) and is used to control gear setting signals. ...
Circuit Diagram ...
Inspection Power Seat Motor 1. Disconnect the connectors for each motor. A : Front height motor B : Slide motor C : Rear height motor D : Recline motor E : Lumber support motor 2. With the battery connected directly to the motor terminals, check if the motors run smoothly. 3. Reverse the connections ...
Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting ...