Kia Optima Hybrid: Automatic Transaxle Control System / Inhibitor Switch Description and Operation

Description
Inhibitor switch monitors the lever''s position (P,R,N,D) and is used to control gear setting signals.

SS-B Solenoid Valve (ON/OFF) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Remove the air duct (A). Tightening torque: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft) 3. Remove the air cleaner assembly. (1) Disconnect the breather hose ...

Inhibitor Switch Specifications

Specifications Type: Combination of output signals from 4 terminals Specifications Power supply (V)12Output typeCombination of output signals Signal Code Table PIN No.PP-RRR-NNN-DDSignal "1"12V12V00000Signal ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Audio Remote Control Schematic Diagrams


Circuit Diagram ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Wheel Repair procedures


Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     When using an impact gun, final tightening torque should be checked using a torque wrench. Run out inspection 1. Jack up the vehicle. 2. Measure the wheel ...

© 2025 Copyright www.koptimatfhev.com