Kia Optima Hybrid: Airbag Module / Side Airbag (SAB) Module Repair procedures

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Restraint / Airbag Module / Side Airbag (SAB) Module Repair procedures

Removal
   
The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag.
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the front seat assembly. (Refer to the Body group- Seat)
3.
Remove the seat back assembly. (Refer to the Body group- Seat)
Installation
   
Be sure to install the harness wires so they will not pinch or interfere with other parts.
   
Do not open the lid of the side airbag cover.
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the new seat back assembly.
(Refer to the Body group - Seat)
4.
Install the front seat assembly.
(Refer to the Body group - Seat)
5.
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfere with other parts.
6.
Reconnect the battery negative cable.
7.
After installing the side airbag (SAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Side Airbag (SAB) Module Components and Components Location

Components ...

Curtain Airbag (CAB) Module Description and Operation

Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain airbag by ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Auto Head Lamp Leveling Unit Repair procedures


Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check for operation. If the aim of the head lamps changes smoothly when the head lamp leveling switch is turned. 4. If the operation does not work well, inspect the connector and terminals to be sure they are all making good contact. If ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Power Door Mirror Actuator Repair procedures


Inspection 1. Remove the front door quadrant delta cover. (Refer to the BD group - "Front door") 2. Disconnect the power door mirror connector from the harness. 3. Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly. Mirror Heater Inspection Turn ...

© 2023 Copyright www.koptimatfhev.com