Removal |
1. |
Remove the negative (-) battery terminal. |
2. |
Remove the driver seat in the car.
(Refer to the BD group - "Front seat") |
3. |
Remove the IMS module (A) after loosening 3 screws in the bottom of seat. |
4. |
Disconnect the IMS module connector (A). |
Installation |
1. |
Install the IMS module after reconnecting the connector. |
2. |
Install the driver seat.
|
Description system outline An optimal seat position set by a driver can be memorized in Power seat unit by IMS SW, which enables restoration of seat position set by the driver despite Playing of this function ...
Circuit diagram ...
Interior A Front pillar trim mounting hole (O12)Front pillar trim mounting hole (O8.4)Cowl crossbar mounting hole (O9)Cowl side trim mounting hole(8.4X8.4)Front door checker mounting hole (O13)Seat belt height adjust upper mounting hole (O12)Seat belt height adjust upper mounting hole (O12)Front seat ...
Components Location 1. AVN (A/V & Navigation head unit)2. Midrange speaker3. External amplifier4. Roof antenna (GPS + SDARS)5. Front door speaker6. Rear speaker7. Woofer speaker8. Antenna feeder cable9. Center speaker10. Glass antenna (Radio)11. Back view camera12. Feeder cable joint connector ? ...