| Inspection |
| 1. |
Remove the trunk room left side trim.
(Refer to the BD group - "Interior trim") |
| 2. |
Remove the fuel filler door release actuator (A) after loosening the mounting bolts.
|
| 3. |
Disconnect the release actuator connector (A).
|
| 4. |
Check for continuity between terminal No.1 and No.2.
If there is no continuity, replace the fuel filler door release actuator. |
Components and Components LocationComponent Location 1. Fuel filler door open switch2. Fuel filler door release actuator ...
Fuel Filler Door Open Switch Repair proceduresInspection 1. Remove the driver door trim. (Refer to the BD group - "Front door") 2. Remove the switch assembly connector (A) from the door trim. 3. Check for continuity between the terminal No.1 and No.2. ...
Calibration Procedure If the compass has been calibrated or set to variance zone number incorrectly, or you are driving in specific places (tunnel, parking lot in building, underground parking lot, near transformer substation, etc.), the below conditions may occur. • The display read "C". • The compass ...
Components Location 1. Drive shaft2. Lower arm3. Front disk4. Front strut assembly5. Steering gearbox6. Front stabilizer bar7. Sub frame ...