Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the rear seat.
(Refer to the BD group - "Rear seat") |
3. |
Remove the package tray trim (A).
(Refer to the BD group -"Interior trim") |
4. |
Remove the soundproofing felt (A) to remove the wiring. |
5. |
Remove the high mounted stop lamp after removing screws and hook (A) carefully. |
Installation |
1. |
Install the high mounted stop lamp to the rear package tray. |
2. |
Install the rear package tray trim. |
3. |
Install the rear seat. |
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the lighting switch of the multi-function switch. (Refer to the multi-function switch) 3. With the front fog lamp switch, make sure ...
Removal Rear Combination lamp (Outside) 1. Disconnect the negative (-) battery terminal. 2. Remove the rear combination lamp cover (A). 3. Replace the turn signal lamp bulbs (A) by turning it counterclockwise. ...
Troubleshooting Customer Complaint Analysis Check Sheet There are several areas where a problem can occur: wiring harness, the radio, the CD player, and speaker. Troubleshooting enables you to confine the problem to a particular area.Chart 1 Chart 2 Chart 3 Chart 4 Chart 5 Chart 6 Chart 7 ...
Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor while backing-up. This system is a supplementary function only. ...