Component Location |
1. ATF fill hole (eyebolt) 2. ATF level plug | 3. ATF drain plug |
Component 1. Flange bolt2. Sleeve3. Reaction shaft support assembly4. Driven gear 5. Sleeve6. Driven gear 7. Oil pump housing ...
Inspection ATF level Check When checking the ATF level, be careful not to enter dust, foreign matters, etc. from fill hole. 1. Remove the air duct (A). 2. Remove the eyebolt (A). 3. Add ATF ...
Removal 1. Disconnect the 12V battery negative (-) cable. 2. Remove the knob (A) and boots (B) by pulling the direction of arrow after removing the boots from the console upper cover. 3. Remove the floor console assembly. (Refer to Body - "Console") 4. Disconnect the main connector (A). 5. Disconnect ...
Replacement 1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bolts when removing the front wheel & tire. 2. Disconnect the stabilizer link (B) from the front strut assembly (A) after loosening ...